具體參數

拖泵分類選型

37千瓦（目前國內標準混凝土泵，37千瓦以下為細石砂漿泵）、45千瓦、55千瓦、75千瓦、90千瓦、110千瓦、130千瓦（柴油）、132千瓦、162千瓦（柴油）、174千瓦（柴油）等等。

選擇多大電機混凝土泵，首先要考慮變壓器容量，其次考慮距離混凝土泵的遠近和線徑大小，以免壓降過大造成電流增高或跳閘停機，過大功率造成成本增加和使用不便。電機過小，同時也滿足不了工程需要。

混凝土輸送泵功率、混凝土輸送泵出口壓力、混凝土輸送泵輸送量之間的關系。

一臺混凝土輸送泵的電機功率是決定出口壓力和輸送方量的前提條件，在電機功率一定的情況下，壓力的升高必將使輸送量降低；相反，降低出口壓力，將會使輸送量增加。

為了保證混凝土輸送泵既要有較大輸送量，又能有一定的出口壓力和與之相匹配的經濟功率，在混凝土輸送泵的設計中，大都采用了恒功率柱塞泵；即恒功率值選定后，當出口壓力升高時，油泵輸出排量會自動降低，達到與功率設計相對應的值；如果既要達到出口壓力高，又想得到輸送量大的目的。惟一的途徑就是增加電機功率。

因此，在國家新標準中，引用了混凝土輸送泵的能力指數概念（以MPa·m3/h為度量單位）；即混凝土輸送泵的實際出口壓力與每小時實際輸送量之乘積，該值越大，其能力指數也越大，電機的功率也將越大，由此實現大排量、高揚程的目的。科尼樂公司在設計時，還采用了高低壓切換的功能設計，以滿足不同的施工要求，在經濟狀態下，又能產生較大的輸送量，或者以相同的電機功率，產生較高的出口壓力。